Standard Shank | Width | Length | Jumbo Shank | Width | Length | Type | |
245 246 246-18 |
9" |
296+ 297 297-18 297-24 |
10" |
Moil Point |
![]() |
||
221+ 221-12 221-18 |
7/8" | 9" |
276+ 276C 276-12 276-12C 276-18 276-18C 276-24 276-36 |
15/16" | 9-1/2" |
Flat Chisel |
![]() |
Note: Ajax Jumbo Flat Chisels Marked "C" are Carbon Steel for Concrete. | |||||||
222+ | 7/8" | 9" | 277+ | 15/16" | 9-1/2" | Flat Side Cut Chisel |
![]() |
276-AC |
15/16" | 9-1/2" | Super Cut Chisel |
![]() |
|||
Note: Blade Forged Across Corners of Square for Greater Strength. | |||||||
276-12-2 |
2" | 12" | Wide Chisel |
![]() |
|||
Note: use Ajax no 274-S Split Lower Sleeve with 2" Chisels. | |||||||
241 | 9" | 295 | 9" | Ripper | ![]() |
||
298+ | 7-1/2" | Drift Pin | ![]() |
||||
240 | 9" | 294 | 9" | Exchanger Tube |
![]() |
||
Furnished for 1/2", 5/8", 3/4" 7/8" 1", 1-1/8" & 1-1/4" diameter tubes |
Furnished for various gauge tubes as may be specified. Furnished with 4", 6" or 8" clearance |
||||||
Tube size is maintained immediately next to shearing point, balance of clearance length is relieved by |
See also Non-Sparking tools
Standard Shank |
Length | Jumbo Shank |
Length | Rivet Size |
Clearance | Type | |
223+ 224+ 225+ 226+ 227+ 228 |
9" | 278+ 279+ 280+ 281 282 283 284 |
9-1/2" | 3/8" 1/2" 5/8" 3/4" 7/8" 1" 1-1/8" |
Back Out Punch | ![]() |
|
231 232 233 234+ 235 236 237 238+ 239+ |
9-1/2" 11-1/2" 13-1/2" 9-1/2" 11-1/2" 13-1/2" 9-1/2" 11-1/2" 13-1/2" |
285 286 287 288 289 290 291 292+ 293 |
10" 12" 14" 10" 12" 14" 10" 12" 14" |
5/8" |
4" 6" 8" 4" 6" 8" 4" 6" 8" |
Long Clearance Back Out Punch |
![]() |